Le produit de Pass4Test peut assurer les candidats à réussir le test Juniper JN0-532 à la première fois, mais aussi offrir la mise à jour gratuite pendant un an, les clients peuvent recevoir les ressources plus nouvelles. Pass4Test n'est pas seulement un site, mais aussi un bon centre de service.
Passer le test Juniper JN0-532, obtenir le Passport peut améliorer la perspective de votre carrière et vous apporter plus de chances à développer votre boulot. Pass4Test est un site très convenable pour les candidats de test Certification Juniper JN0-532. Ce site peut offrir les informations plus nouvelles et aussi provider les bonnes chances à se former davantage. Ce sont les points essentiels pour votre succès de test Certification Juniper JN0-532.
Participer au test Juniper JN0-532 est un bon choix, parce que dans l'Industire IT, beaucoup de gens tirent un point de vue que le Certificat Juniper JN0-532 symbole bien la professionnalité d'un travailleur dans cette industrie.
Code d'Examen: JN0-532
Nom d'Examen: Juniper (FWV,Specialist (JNCIS -FWV))
Questions et réponses: 146 Q&As
Le test Juniper JN0-532 est une examination de techniques professionnelles dans l'Industrie IT. Pass4Test est un site qui peut vous aider à réussir le test Juniper JN0-532 rapidement. Si vous utiliser l'outil de formation avant le test, vous apprendrez tous essences de test Certification Juniper JN0-532.
La grande couverture, la bonne qualité et la haute précision permettent le Pass4Test à avancer les autre sites web. Donc le Pass4Test est le meilleur choix et aussi l'assurance pour le succès de test Juniper JN0-532.
Pass4Test est un site d'offrir l'outil de formation convenable pour les candidats de test Certification IT. Le produit de Pass4Test peut aider les candidats à économiser les temps et les efforts. L'outil de formation est bien proche que test réel. Vous allez réussir le test 100% avec l'aide de test simulation de Pass4Test. C'est une bonne affaire à prendre le Certificat IT en coûtant un peu d'argent. N'hésitez plus d'ajouter l'outil de formation au panier.
JN0-532 Démo gratuit à télécharger: http://www.pass4test.fr/JN0-532.html
NO.1 Click the Exhibit button.
In the exhibit, what is the source IP address of the multicast traffic?
A.236.1.1.1
B.10.10.10.1
C.20.20.20.10
D.20.20.20.200
Answer: B
Juniper certification JN0-532 JN0-532 examen JN0-532 JN0-532
NO.2 Click the Exhibit button.
In the exhibit, which two can be determined about the VPN? (Choose two.)
A.NAT-traversal is enabled.
B.The rekey interval is 8 hours.
C.This device initiated the Phase 1 negotiations.
D.The certificate used in this exchange is set to never expire.
Answer: BC
Juniper JN0-532 JN0-532 JN0-532 examen certification JN0-532 JN0-532 examen
NO.3 Click the Exhibit button.
In the exhibit, the firewall administrator at the Storefront is complaining that when the communication to
the DataCenter1 fails, the preexisting transfers and applications are dropped when the traffic is switched
to DataCenter2.
Which statement explains this behavior?
A.SYN checking is enabled in the tunnel.
B.The weight value for the DataCenter2 is too high.
C.VPN monitor is misconfigured in the DataCenter2.
D.Phase 1 and Phase 2 negotiations to DataCenter2 did not occur on time.
Answer: A
certification Juniper certification JN0-532 JN0-532
NO.4 Which command is used to verify that IGMP is running correctly?
A.get route igmp
B.get igmp query
C.set igmp query interface e0/1
D.exec igmp interface e0/1 query
Answer: D
Juniper JN0-532 JN0-532 examen JN0-532 examen
NO.5 What must be enabled to protect Phase 2 key exchanges?
A.Phase 1 PFS
B.Phase 2 SHA
C.Phase 2 3-DES
D.Phase 2 DH key exchange tiations? (Choose two.)
A.proxy-id, SA proposal list
B.IKE cookie, SA proposal list
C.hash [ID + Key], DH key exchange
D.SA proposal list, optional DH key exchange
Answer: D
Juniper examen certification JN0-532 JN0-532 examen JN0-532 JN0-532 JN0-532 examen
NO.6 Which ScreenOS CLI command is necessary for configuring IGMP on interface ethernet0/1?
A.set igmp interface ethernet0/1
B.set multicast interface ethernet0/1
C.set interface ethernet0/1 igmp router
D.set igmp interface ethernet0/1 enable
Answer: C
Juniper JN0-532 examen JN0-532 examen
NO.7 Which CLI command identifies the multicast sources visible to your ScreenOS device?
A.get route pim
B.get igmp source all
C.exec pim interface all query
D.get vrouter trust-vr protocol pim
Answer: D
certification Juniper JN0-532 examen certification JN0-532
NO.8 To which three ScreenOS components can a policy-based routing policy be bound? (Choose three.)
A.zone
B.policy
C.interface
D.virtual router
E.virtual system
Answer: ACD
Juniper JN0-532 certification JN0-532
NO.9 Which three statements are true regarding IKE Phase 1? (Choose three.)
A.Placing the SA proposal list in message 1 is an option.
B.The digital certificate is used to decrypt the session key.
C.The DH key exchange is used to validate the session key.
D.The DH key exchange and digital certificates are both optional.
E.The proxy-id is used to determine which SA is referenced for the VPN.
Answer: ABC
Juniper JN0-532 JN0-532 examen
NO.10 You have entered the command set ffilter src-ip 1.1.7.250 dst-ip 10.1.10.5 ip-prot 6
What will be the resulting output in the debug for which this was created?
A.If the packet has a src-ip of 1.1.7.250 or a dst-ip of 10.1.10.5 or has TCP as its protocol then it will be
captured
B.If the packet has a src-ip of 1.1.7.250 or a dst-ip of 10.1.10.5 or has UDP as its protocol then it will be
captured
C.If the packet has a src-ip of 1.1.7.250 and a dst-ip of 10.1.10.5 and has TCP as its protocol then it will
be captured
D.If the packet has a src-ip of 1.1.7.250 and a dst-ip of 10.1.10.5 and has UDP as its protocol then it will
be captured
Answer: C
Juniper examen JN0-532 JN0-532 JN0-532 JN0-532
NO.11 Which two item pairs are exchanged during Phase 2 negotiations? (Choose two.)
A.proxy-id, SA proposal list
B.IKE cookie, SA proposal list
C.hash [ID + Key], DH key exchange
D.SA proposal list, optional DH key exchange
Answer: AD
Juniper certification JN0-532 certification JN0-532
NO.12 Which three OSPF parameters are interface parameters? (Choose three.)
A.cost
B.priority
C.neighbor list
D.summarization
E.advertise default route
Answer: ABC
certification Juniper JN0-532 certification JN0-532 JN0-532 JN0-532 examen
NO.13 Review the exhibit.
You've been asked to build a route-based hub and spoke network, with policy control for traffic travelling
from spoke to spoke. Which two of the following configuration options will meet this requirement?
(Choose two.)
A.Place the spoke tunnel interfaces in the trust zone and create policies on the spokes.
B.Place the spoke tunnel interfaces in the untrust zone and create policies on the spokes.
C.Create a single tunnel interface in the trust zone at the hub and enable intra-zone blocking.
D.Create separate tunnel interfaces at the hub and place them in different zones, then create policies at
the hub.
Answer: BD
Juniper certification JN0-532 JN0-532 JN0-532 JN0-532 JN0-532
NO.14 Click the Exhibit button.
In the exhibit, what is the address of the multicast receiver?
A.234.9.8.42
B.192.168.10.2
C.192.168.20.10
D.192.168.20.200
Answer: D
Juniper examen JN0-532 JN0-532 JN0-532 examen
NO.15 You have created a virtual router called VSYSA-vr and made it shareable. You then create the VSYS
using the WebUI, telling it to use an existing VR and selecting the VR called VSYSA-vr.
What is the status of the virtual router after you create the VSYS?
A.The router will be the default router but will no longer be shared.
B.The router will be the default router and will still have a shareable status.
C.The system will not let you use a shared virtual router when you create a new VSYS. The initial virtual
router must be private.
D.The system will not create a private vr for the VSYS but will assign the untrust-vr as the default router.
The shared Virtual router will not be the default router.
Answer: B
Juniper examen certification JN0-532 JN0-532 examen JN0-532 examen
NO.16 During main mode negations a failure has occurred while using IKE certificates.
Which message pair would you review to troubleshoot this failure?
A.messages 1 & 2
B.messages 2 & 3
C.messages 3 & 4
D.messages 5 & 6
Answer: D
certification Juniper certification JN0-532 JN0-532 certification JN0-532 certification JN0-532
NO.17 Review the exhibit.
Which two of the following elements must be configured on the ScreenOS device in order to support
PIM-SM? (Choose two)
A.A multicast control policy
B.A bootstrap router process
C.A unicast routing protocol
D.A static RP
Answer: AC
Juniper examen JN0-532 JN0-532 JN0-532
NO.18 What must be configured differently for a route-based VPN and a policy-based VPN?
A.proxy-id
B.proposals
C.remote gateway type
D.binding the tunnel interface
Answer: D
Juniper examen certification JN0-532 JN0-532 JN0-532 JN0-532
NO.19 You have configured the following on your device.
set address trust MyPC 10.1.1.5/32
set address untrust CorpNet 10.10.0.0/16
set policy from trust to untrust MyPC CorpNet any permit
set int tunnel.1 zone untrust
set int tunnel.1 ip unnumbered int bgroup1
set ike gateway GW address 1.1.1.1 outgoing-interface e0/1 preshare Secret sec-level standard
set vpn VPN gateway GW sec-level standard
The tunnel interface is down, so the VPN cannot function properly. What is the problem?
A.The policy needs to have the action tunnel.
B.The VPN needs to be bound to the tunnel interface.
C.The tunnel interface needs to be placed in the trust zone.
D.The tunnel interface needs to be associated with the interface in the untrust zone.
Answer: B
Juniper JN0-532 examen JN0-532 examen
NO.20 Click the Exhibit button.
Review the exhibit. Track-ip has failed on the device, but the device did not fail over to the second unit in
the cluster:
Why has failover not occurred?
A.The physical interfaces have not failed.
B.The track-ip interval is not sufficient to cause failover.
C.The track-ip address weight is not sufficient to cause failover.
D.The track-ip address threshold is not sufficient to cause failover.
Answer: C
Juniper JN0-532 examen certification JN0-532
On doit faire un bon choix pour passer le test Juniper JN0-532. C'est une bonne affaire à choisir la Q&A de Pass4Test comme le guide d'étude, parce que vous allez obtenir la Certification Juniper JN0-532 en dépensant d'un petit invertissement. D'ailleur, la mise à jour gratuite pendant un an est aussi gratuite pour vous. C'est vraiment un bon choix.
没有评论:
发表评论